8PCs of add-on flex circuit boards are for fixing the consistent drifting issue of your controllers. Solder it onto the back of problem joystick, adjust the tiny variable resistor against the drifting direction. It calibrates your analog sticks in hardware level. 10K and 2K ohm versions included. Works with the sticks made by ALPS, FU and other 3rd parties
Before Buying:
1. Evaluate if you’re handy with basic soldering skills and DIY gear
2. Refer to the compatible list or Make sure the sensor is 3Pin 2KΩ or 10KΩ
3. Make sure the thumbstick drifts in one fixed direction
4. Please go to ElecGear replacement joysticks or potentiometers instead for problems below:
(Random drifting, Stuck movement, Stuttering, Blind spot, Dead zone or No reaction when clicking)
✅Known 2KΩ Compatible Controllers:
PS5 DualSense, some latest PS4 Pro controller
✅Known 10KΩ Compatible Controllers:
PS4, PS4 Slim and PS4 Pro, PS3 (3Pin Version), PS2
Xbox Series S|X, Xbox One S|X, Xbox Elite 1/2, Xbox 360
Steam Deck
Switch Pro
8Bitdo SNES, Nvidia Shield, Scuf Impact, GameCube, Wii U, PDP
Some Drone and VR Headset remote controller, like DJI
❌Known Incompatible Controller:
Switch Lite, Switch Joycon, N64, 2DS, 3DS
Oculus Quest
Sony PS Vita, PSP
Most Arcade, Flight or Fighter Stick
How to DIY?
1. Measure the resistance of the potentiometer: 10K or 2K
2. Decide if the PCB should be cut into two parts
3. Teardown your controller
4. Solder the PCB onto the back of joystick
5. Adjust the trimmer pot to eliminate the drifting
Packaging:
4x Drift Fix PCB Rev.2K
4x Drift Fix PCB Rev.10K
1x Slotted Adjusting Tool
1x PH000 Screwdriver
1x Pry Opening Tool
(🔺Soldering tools are Not included! And Not all teardown tools included!)
